Use the licensed feature to enable or disable the vFlash
SD card, check the health and properties, and initialize the vFlash
SD card. Lifecycle Controller support vFlash SD cards of sizes 1 GB,
2 GB, 8 GB, 16 GB, and 32 GB.
NOTE: The options under
vFlash SD card are grayed-out if there is no SD card inserted in the
slot.
NOTE: If FIPS is enabled,
you cannot perform any actions associated with the vFlash SD card,
such as configuring the vFlash SD card, exporting or backing up server
profile to the vFlash, or importing server profile using vFlash.
See the Integrated Dell Remote Access Controller
(iDRAC) User’s Guide available at www.dell.com/support/home for more information on vFlash SD card and the installation procedure.
Use the vFlash SD card configuration feature to:
Enable or disable vFlash SD card.
Determine the vFlash SD card properties:
Name—Displays the name of the
vFlash SD card.
Health—Displays health states
such as OK, Warning,
and Critical.
Size—Indicates the total size
of the vFlash SD card.
Available Space—Indicates the
available size on the vFlash SD card to create a partition.
Write Protected—Indicates if
the write-protect latch on the vFlash SD card is set to on or off
position.
Initialize vFlash — Deletes
all the existing partitions on the vFlash SD card.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\