Dell Host Bus Adapter User's Guide HBA 355 and 350 Series

Device Properties

Device properties allows you to view the properties of the device.

1. To view the Device Properties screen, power on the system, press F2, and click System Setup Main Menu > Device Settings > Dell HBA355i Front Configuration Utility > Device Properties > Logical Enclosure (Bay ID=1, Enclosure Level=1).

   Table 1. Logical Enclosure (Bay ID=1, Enclosure Level=1) propertiesThe table describes the fields on the Logical Enclosure (Bay ID=1, Enclosure Level=1) properties:

   Option	Description
   Enclosure logical ID	Logical ID of the enclosure
   Enclosure level	Level of the enclosure
   Bay ID	Bay ID of the enclosure
   Vendor name	Vendor name of the enclosure
   Product name	Product name of the enclosure
   Product revision	Product revision of the enclosure
   Number of slots	Number of slots that the enclosure supports

2. Click <Slot 0> SAS SSD drive model to view the properties on this device.
   If the physical disk ID has the letter M next to it, the disk has multiple paths that are connected to the system.

   Table 2. Device at Slot 0 Logical Enclosure 1 propertiesThe table describes the fields on the Device at Slot 0 Logical Enclosure 1:

   Option	Description
   Device type	Type of the drive
   Protocol	The drive protocol
   Slot number	Drive slot number in the enclosure
   Connector name	Name of the port as displayed in the utility
   Vendor name	Vendor name of the drive
   Product name	Product name of the drive
   Revision name	Revision version of the drive
   Serial number	Serial number of the drive
   Capacity	Capacity of the drive
   Logical/Physical sector size	Sector size of the selected drive
   Multipath device	Drive supports multipath or not
   SAS address	SAS address of the drive
   Negotiated logical link rate	Negotiated logical link rate of the device
   Negotiated physical link rate	Negotiated physical link rate of the device
   Maximum drive rate	Maximum possible drive rate
   Write cache	You can either enable or disable the Write Cache
   Locate LED	You can either select On or Off the locate LED
   Legacy OpROM boot device	You can either select Yes or No

3. Click Apply Changes to submit the changes selected.
   A confirmation screen is displayed. Click Ok to continue.
4. To choose another device click Next Device in this Enclosure.