Dell Host Bus Adapter User's Guide HBA 355 and 350 Series

Install the Dell HBA355e Adapter

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

You have read and complied with the safety guidelines listed in Safety instructions.
You have completed the procedures in Before working inside your system.

Steps

Unpack your HBA355e Adapter.
Attach the bracket with the card using the screws provided.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
NOTE: For more information about power support units (PSUs), see the owner's manual of your system Dell.com/poweredgemanuals.
Disconnect the system from the network.
Remove the cover of the system.
Select an appropriate PCIe slot.
NOTE: To avoid damage to the controller, hold the controller by its edges only.
Align the connector on the HBA355e Adapter with the PCIe slot on the system.
Press down the controller until the connectors are firmly engaged.
Tighten the screws on the bracket, if any, or use retention clips of the system to secure the controller on the system.
Use SAS cables to connect the external tape device or enclosure to the adapter.
Install the system cover.
Reconnect the power cables and network cables, and then turn on the system.
Figure 1. Install the HBA355e Adapter. This image shows how to install the HBA355e Adapter.

Welcome

Welcome to Dell

Dell Host Bus Adapter User's Guide HBA 355 and 350 Series

Install the Dell HBA355e Adapter

Prerequisites

Steps

Rate this content