Manage replication schedules from the Volumes topic
You can modify or delete scheduled replication tasks on the primary system.
Modify scheduled replication tasks from the Volumes topic
From the Replication Sets table on the primary system, select a replication set that has an associated schedule.
Select
Action > Manage Schedules. The Manage Schedules panel opens.
Select the schedule to modify.
The schedule settings appear at the bottom of the panel.
If you want to create a replication of the last snapshot in the primary volume, select the
Last Snapshot check box.
At the time of the replication, the snapshot must exist. This snapshot may have been created either manually or by scheduling the snapshot.
NOTE:This option is unavailable when replicating volume groups.
Specify a date and a time in the future to specify when to run the scheduled task. This date and time is also the starting point for any specified recurrence.
To set the
Date value, enter the current date in the format
YYYY-MM-DD.
To set the
Time value, enter two-digit values for the hour and minutes and select either
AM, PM, or
24H (24-hour clock).
If you want the task to run more than once, select the
Repeat check box.
Specify how often the task should repeat. Enter a number, and select the appropriate time unit. Replications can recur no less than 30 minutes apart.
To allow the schedule to run without an end date, clear the
End check box. To specify when the schedule should stop running, select the
End check box
To allow the schedule to run at any time, clear the
Time Constraint check box. To specify a time range within which the schedule can run, select the
Time Constraint check box.
To allow the schedule to run on any day, clear the
Date Constraint check box. To specify the days when the schedule can run, select the
Date Constraint check box.
Click
Apply.
A confirmation panel appears.
Click
OK.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\