Perform the following steps to configure DNS settings:
Perform one of the following to access Network options:
In the Home topic, select
Action > System Settings, and then click the
Network tab.
In the System topic, select
Action > System Settings, and then click the
Network tab.
Select the
DNS tab.
Enter a hostname in the
Hostname text box to set a domain hostname for each controller module. Use the following naming conventions:
The name must differ for each controller.
The name can have from 1 byte to 63 bytes.
The name is not case-sensitive.
The name must start with a letter and end with a letter or digit.
The name can include letters, numbers, or hyphens; no periods.
Enter up to three network addresses for each controller in the DNS Servers fields.
The resolver queries the network in the order that is listed until reaching a valid destination address. Any valid setting is treated as enabling DNS resolution for the system.
Specify up to three domain names for each controller in the
Search Domains fields to search when resolving host names that are configured in the storage system.
The resolver queries the network in the order that is listed until finding a match.
NOTE:To reset Hostname to its default setting, select the
Reset button for each controller. To clear the configured DNS Servers and Search Domains, select the Clear
DNS Settings button for each controller.
Perform one of the following:
To save your settings and continue configuring your system, click
Apply.
To save your settings and close the panel, click
Apply and Close.
A confirmation panel appears.
Click
Yes to save your changes. Otherwise, click
No.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\