Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

controller ovsdb

Changes the mode to CONFIGURATION-NVE-OVSDB from where you can configure the controller parameters.

Syntax
controller ovsdb
Parameters
None
Default
None
Command mode
CONFIGURATION-NVE
Usage information

The controller configuration initiates the OVSDB service on the OS10 switch.

The no version of this command stops the OVSDB service. The no version command fails if any ports are configured as controller-managed ports or IP address configuration.

NOTE Before removing the controller configuration from the device, you must delete all controller-managed ports and IP address configuration.
Example
OS10(config)# nve
OS10(config-nve)# controller ovsdb
Supported releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\