Configures a dedicated Loopback interface as
the source VTEP.
Syntax
source-interface loopback number
Parameters
loopback number
Enter the Loopback interface used as the source interface
of a VXLAN virtual tunnel, from 0 to 16383.
Default
Not configured
Command mode
NVE-INSTANCE
Usage information
The IP address of the Loopback interface serves
as the source IP address in encapsulated packets transmitted from
the switch as an NVE VTEP.
The Loopback interface
must have an IP address configured. The Loopback IP address must be
reachable from the remote VTEP.
You cannot change the
source interface if at least one VXLAN virtual network ID (VNID) is
configured for the NVE instance.
Use this command in NVE mode to
override a previously configured value and reconfigure the source
IP address. The no version of this
command removes the configured value.
Examples
OS10(config-nve)# source-interface loopback 1
Supported releases
10.4.2.0 or later
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\