- Notes, cautions, and warnings
- Working on your computer
- Disassembly
and reassembly
- Recommended tools
- Screw list
- Base cover
- Battery
- WLAN card
- Memory modules
- Solid-state drive
- Hard drive
- Speakers
- Graphics Processing Unit (GPU) fan
- CPU fan
- Heat sink
- Coin-cell battery
- I/O board
- Power button with optional fingerprint reader
- Power-adapter port
- Touchpad
- Display assembly
- Display bezel
- System board
- Palmrest assembly
- Software
- System setup
- Troubleshooting
- Getting help
Vostro 7590 Service Manual
Removing the display assembly
Prerequisites
- Follow the procedure in Before working inside your computer .
- Remove the base cover.
- Remove the battery.
- Remove the WLAN card.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
Steps
- Locate the display cable and display hinges on your computer.
- Peel the tape that secures the display cable to the system board.
- Open the latch and disconnect the display cable from the system board.
- Remove the three screws (M2.5x5) that secure the left-display hinge to the system board.
- Remove the three screws (M2.5x5) that secure the right-display hinge to the system board.
- Open the display hinges at an angle of 90 degrees.
- Remove the palm-rest and keyboard assembly off the display assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\