Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

crypto ipsec transform-set

Create a transform set, or combination of security algorithms and protocols, of cryptos.

Syntax crypto ipsec transform-set name {ah-authentication {md5|sha1|null} | esp-authentication {md5|sha1|null} | esp-encryption {3des|cbc|des|null}}

To delete a transform set, use the no crypto ipsec transform-set name {ah-authentication {md5|sha1|null} | esp-authentication {md5|sha1|null} | esp-encryption {3des|cbc|des|null}} command.

Parameters
name Enter the name for the transform set.
ah-authentication Enter the keywords ah-authentication then the transform type of operation to apply to traffic. The transform type represents the encryption or authentication applied to traffic.
  • md5 — Use Message Digest 5 (MD5) authentication.
  • sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
  • null — Causes an encryption policy configured for the area to not be inherited on the interface.
esp-authentication Enter the keywords esp-authentication then the transform type of operation to apply to traffic. The transform type represents the encryption or authentication applied to traffic.
  • md5 — Use Message Digest 5 (MD5) authentication.
  • sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
  • null — Causes an encryption policy configured for the area to not be inherited on the interface.
esp-encryption Enter the keywords esp-encryption then the transform type of operation to apply to traffic. The transform type represents the encryption or authentication applied to traffic.
  • 3des — Use 3DES encryption.
  • cbc — Use CDC encryption.
  • des — Use DES encryption.
  • null — Causes an encryption policy configured for the area to not be inherited on the interface.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
  • Both sides of the link must specify the same transform set.
  • You can create up to 64 transform sets.
Example 
Dell(conf)#int ten 0/4
                                             Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
                                             Dell(conf)#int ten 0/6
                                             Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\