Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug uplink-state-group

Enable debug messages for events related to a specified uplink-state group or all groups.

Syntax debug uplink-state-group [ group-id]

To turn off debugging event messages, enter the no debug uplink-state-group [group-id] command.

Parameters
group-id Enables debugging on the specified uplink-state group. The valid group-id values are from 1 to 16.
Defaults none
Command Modes EXEC Privilege
Supported Modes Programmable-Mux (PMUX)

Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Related Commands clear ufd-disable — re-enables downstream interfaces that are in a UFD-Disabled Error state.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\