Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug dcbx

Enable DCBX debugging.

Syntax

debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt | resource | sem | tlv}

To disable DCBX debugging, use the no debug dcbx command.

Parameters

{all | auto-detect-timer | config-exchng | fail | mgmt | resource | sem | tlv}

Enter the type of debugging, where:

all: enables all DCBX debugging operations.
auto-detect-timer: enables traces for DCBX auto-detect timers.
config-exchng: enables traces for DCBX configuration exchanges.
fail: enables traces for DCBX failures.
mgmt: enables traces for DCBX management frames.
resource: enables traces for DCBX system resource frames.
sem: enables traces for the DCBX state machine.
tlv: enables traces for DCBX TLVs.

Defaults

none

Command Modes

EXEC Privilege

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.3(0.0)	Introduced on the FC Flex IO module installed in the M I/O Aggregator.