Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip ospf neighbor

Display the OSPF neighbors connected to the local router.

Syntax

show ip ospf process-id neighbor

Parameters

process-id

Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process.

Command Modes

EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip ospf process-id neighbor command shown in the following example.

Item	Description
Neighbor ID	Displays the neighbor router ID.
Pri	Displays the priority assigned neighbor.
State	Displays the OSPF state of the neighbor.
Dead Time	Displays the expected time until the system declares the neighbor dead.
Address	Displays the IP address of the neighbor.
Interface	Displays the interface type slot/port information.
Area	Displays the neighbor’s area (process ID).

Example

Dell#show ip ospf 34 neighbor
                                             
                                             Neighbor ID Pri State       Dead Time Address  Interface Area
                                             20.20.20.7  1 FULL/DR     00:00:32 182.10.10.3 Gi 0/0 0.0.0.2
                                             192.10.10.2 1 FULL/DR     00:00:37 192.10.10.2 Gi 0/1 0.0.0.1
                                             20.20.20.1  1 FULL/DROTHER00:00:36 192.10.10.4 Gi 0/1 0.0.0.1
                                             Dell#