Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

group

Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).

Syntax

group group_number port-channel number port-channel number

To remove an existing LAG supergroup, use the no group group_number command.

Parameters

group_number	Enter an integer from 1 to 32 that uniquely identifies this LAG fate-sharing group.
port-channel number	Enter the keywords `port-channel` then an existing LAG number. Enter this keyword/variable combination twice, identifying the two paired LAGs.

Defaults

none

Command Modes

PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the M I/O Aggregator.

Example

Dell(conf)#port-channel failover-group
                                             Dell(conf-po-failover-grp)#group 1 port-channel 1 port-channel 2
                                             Dell(conf-po-failover-grp)#

Related Commands

port-channel failover-group — accesses PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover group.

show interfaces port-channel — displays information on configured Port Channel groups.