Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

show vrrp

View the VRRP groups that are active. If no VRRP groups are active, the system returns No Active VRRP group.

show vrrp [ vrrp-id] [ interface] [brief]

vrrp-id	(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to view only that group. The range is from 1 to 255.
interface	(OPTIONAL) Enter the following keywords and slot/port or number information: For Port Channel interface types, enter the keywords `port-channel` then the number. The range is from 1 to 128. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information. For a VLAN interface, enter the keyword `vlan` then the VLAN ID. The VLAN ID range is from 1 to 4094.
brief	(OPTIONAL) Enter the keyword `brief` to view a table of information on the VRRP groups.

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show vrrp brief command shown in the following example.

Item	Description
Interface	Lists the interface type, slot and port on which the VRRP group is configured.
Grp	Displays the VRRP group ID.
Pri	Displays the priority value assigned to the interface. If the `track` command is configured to track that interface and the interface is disabled, the cost is subtracted from the priority value assigned to the interface.
Pre	States whether preempt is enabled on the interface. `Y` = Preempt is enabled. `N` = Preempt is not enabled.
State	Displays the operational state of the interface by using one of the following: NA/IF (the interface is not available). MASTER (the interface associated with the MASTER router). BACKUP (the interface associated with the BACKUP router).
Master addr	Displays the IP address of the MASTER router.
Virtual addr(s)	Displays the virtual IP addresses of the VRRP routers associated with the interface.

Example (Brief)

Dell>Interface Grp Pri Pre State Master addr Virtual addr(s)
                                             Description-----------------------------------------------------
                                             TenGig 1/9 1 100 Y Master 200.200.200.200 200.200.200.201
                                             TenGig 1/9  2 100 Y Master 200.200.200.200 200.200.200.202 200.200.200.203
                                             Description
                                             TenGig1/9  3 100 Y Master 1.1.1.1 1.1.1.2
                                             TenGig1/9  4 100 Y Master 200.200.200.200 200.200.200.206 200.200.200.207 ... short
                                             desc
                                             
                                             Dell>

Usage Information

The following describes the show vrrp command shown in the following example.

Item	Description
State: master...	Displays the interface’s state: Na/If (not available) master (MASTER virtual router) backup (BACKUP virtual router) the interface’s priority and the IP address of the MASTER.
Hold Down:...	This line displays additional VRRP configuration information: Hold Down displays the hold down timer interval in seconds. Preempt displays TRUE if preempt is configured and FALSE if preempt is not configured. AdvInt displays the Advertise Interval in seconds.
Adv rcvd:...	This line displays counters for the following: Adv rcvd displays the number of VRRP advertisements received on the interface. Adv sent displays the number of VRRP advertisements sent on the interface. Gratuitous ARP sent displays the number of gratuitous ARPs sent.
Virtual MAC address	Displays the virtual MAC address of the VRRP group.
Virtual IP address	Displays the virtual IP address of the VRRP router to which the interface is connected.
Authentication:...	States whether authentication is configured for the VRRP group. If it is, the authentication type and the password are listed.
Tracking states..	This line is displayed if the `track` command is configured on an interface. Below this line, the following information on the tracked interface is displayed: Dn or Up states whether the interface is down or up. the interface type slot/port information.

Example

Dell>show vrrp
                                             ------------------
                                             TenGigabitEthernet 1/3, VRID: 1, Net: 10.1.1.253
                                             VRF: 0 default                   
                                             State: Master, Priority: 105, Master: 10.1.1.253 (local)
                                             Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
                                             Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
                                             Virtual MAC address:
                                             00:00:5e:00:01:01
                                             Virtual IP address:
                                             10.1.1.252
                                             Authentication: (none)
                                             Tracking states for 1 interfaces:
                                             Up TenGigabitEthernet 1/13 priority-cost 10
                                             ------------------
                                             TenGigabitEthernet 1/4, VRID: 2, Net: 10.1.2.253
                                             VRF: 0 default                   
                                             State: Master, Priority: 110, Master: 10.1.2.253 (local)
                                             Hold Down: 10 sec, Preempt: TRUE, AdvInt: 1 sec
                                             Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
                                             Virtual MAC address:
                                             00:00:5e:00:01:02
                                             Virtual IP address:
                                             10.1.2.252
                                             Authentication: (none)
                                             Tracking states for 2 interfaces:
                                             Up TenGigabitEthernet 2/1 priority-cost 10
                                             Up TenGigabitEthernet 3/8 priority-cost 10
                                             Dell>

Bienvenido

Bienvenido a Dell

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

show vrrp

Califique este contenido