Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

track ip

Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.

Syntax

track ip interface

To remove the tracking feature from the VLAN, use the no track ip interface command.

Parameters

interface

Enter the following keywords and slot/port or number information:

For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

Defaults

Not configured.

Command Modes

INTERFACE VLAN

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

When this command is configured, the VLAN is operationally UP if any of the interfaces specified in the track ip command are operationally UP, and the VLAN is operationally DOWN if none of the tracking interfaces are operationally UP.

If the track ip command is not configured, the VLAN's Layer 3 operational state depends on all the members of the VLAN.

The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the track ip command configuration.

Related Commands

interface vlan — configures a VLAN.

tagged — specifies which interfaces in a VLAN are tagged.