Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

vlan tagged (CMC)

Add a Layer 2 interface to a VLAN as a tagged interface.

Syntax

vlan tagged [ vlan-id]

To remove a tagged interface from a VLAN, use the no vlan tagged vlan-id command.

Parameters

vlan-id

Enter the VLAN ID. The range is from 1 to 4094.

Defaults

All interfaces in Layer 2 mode are untagged.

Command Modes

INTERFACE

Supported Modes

All Modes

Command History

Version	Description
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

If the interface belongs to several VLANs, you must remove it from all VLANs to change it to an untagged interface.

Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong to one VLAN at a time.

When two or more ports configured for VLANs form a LAG, the resulting LAG is a tagged member of all the configured VLANs and an untagged member of the VLAN to which the port with the lowest port ID belongs.

For example, if port 0/1-32 is an untagged member of VLAN 2 and port 0/41 is an untagged member of VLAN 3, the resulting LAG consisting of the two ports is an untagged member of VLAN 2 and a tagged member of VLAN3.

Example

Dell(conf-if-te-0/2)#vlan tagged ?
                                             VLAN-RANGE        Comma/Hyphen separated VLAN ID set
                                             Dell(conf-if-te-0/2)#vlan tagged 2,3-4
                                             Dell(conf-if-te-0/2)#show config
                                             !
                                             interface TenGigabitEthernet 0/2
                                             mtu 12000
                                             vlan tagged 2-4
                                             !
                                             port-channel-protocol LACP
                                             port-channel 1 mode active
                                             !
                                             protocol lldp
                                             advertise management-tlv system-name
                                             dcbx port-role auto-downstream
                                             no shutdown
                                             Dell(conf-if-te-0/2)#

Related Commands

interface vlan — Configures a VLAN.

vlan untagged — Specifies which interfaces in a VLAN are untagged.