Global hot spare disk is a backup physical
disk that can be used by any redundant virtual disk. It is not assigned
(dedicated) to any specific virtual disk. Virtual disks can typically
be rebuilt by using a global spare disk, as long as the global hot
spare is not already part of the virtual disk and has enough available
capacity. Unlike a dedicated hot spare, a global hot spare can be
assigned at anytime, even while tasks are running on virtual disks.
NOTE: A hot spare can be
created only if a physical disk is in Ready or Normal state, in the Physical
Disks field. If the physical disk is in Online state, the disk is being used by a virtual disk and cannot be selected
as a hot spare.
Perform the
following procedure to assign a global hot spare disk:
In the Main Menu screen,
select the Manage Hot Spare and press <Enter>.
Select Assign Global Hot Spare(s). Press <Enter>.
NOTE: Assign global hot spare only from disk drives populated across slots
0-3 of the system. For information about the disk connectivity for
AHCI devices, see Disk connectivity for AHCI devices, and for disks slot information, see the system specific
Owner's Manual at dell.com/poweredgemanuals.
Use the up or down arrow key to select a physical
disk(s) to be used as a global hot spare(s). Press <Insert>.
Press <Enter> to add the global hot spare.
Press the <C> key to confirm the action.
Non sono disponibili i dati per l'argomento
Fornisci una valutazione (1-5 stelle).
Fornisci una valutazione (1-5 stelle).
Fornisci una valutazione (1-5 stelle).
Indica se l'articolo è stato utile o meno.
I commenti non possono contenere i seguenti caratteri speciali: <>() \