Dell EMC PowerEdge RAID Controller S130 User’s Guide

Configuring Windows RAID

1. Enter the Dell PERC S130 Configuration Utility. See Entering the DELL PERC S130 Configuration Utility.
2. Click Controller Management → Convert to RAID capable disk.
3. Select Windows RAID.
   NOTE: Create boot virtual disk only from disk drives populated across slots 0-3 of the system. For information about the disk connectivity for AHCI devices, see Disk connectivity for AHCI devices.
4. Select Select physical disks from slots other than slots 0-3 to enable the selection of the physical disk(s) that are on slot 4 and all slots after.
5. Select the physical disk(s) and click OK.
   A confirmation screen is displayed.
6. Click Yes to continue.
7. After converting the physical disks, click the Virtual Disk Management in the Controller Options screen.
8. Click Create Virtual Disks
9. Click Select the Physical Disk.
10. Select media type and the physical disks.
11. Click OK.
    A confirmation screen is displayed.
12. Click Yes to continue.