Passa al contenuto principale
Esci

Benvenuto in Dell

Il mio account
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.
Accedi Crea un account Accesso a Premier Accesso al Partner Program
Contattaci

I tuoi carrelli Dell.com

Dell EMC PowerEdge RAID Controller S130 User’s Guide

PDF

Cabling the drives for S130

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: For information on removing and reinstalling system parts, see the PowerEdge Systems Owner’s Manuals at dell.com/poweredgemanuals.

This section provides details about the cabling information for the integrated PERC S130 controller.

NOTE: For information about cabling the drives for S130, see the hardware owner's manual of specific system available at dell.com/poweredgemanuals.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
    NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
  2. Remove the system cover.
  3. Locate the connectors J_SATA A and J_SATA B on the system board.
  4. Connect the J_SATA A and J_SATA B connectors on the AHCI devices to the corresponding cable connectors on the backplane using the SATA cables.
    NOTE: The first AHCI device provides connectivity to the drives available on port 0–3 and the second AHCI device provides connectivity to the drives available on port 4–7. For information about disk connectivity for AHCI devices, see Disk connectivity for AHCI devices.
  5. Install the system cover.
  6. Turn on the system.
    NOTE: Ensure that you create boot LUN only on the hard-drives populated on port 0–3.
    Figure 1. Cabling the S130 controller
    This figure shows cabling the S130 controller.

    1. backplane

    2. system board

    3. connector on the first AHCI device (J_SATA A)

    4. connector on the second AHCI device (J_SATA B)

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \