- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 7490 Service Manual
Installing the display assembly
Prerequisites
About this task
The following image indicates the location of display assembly and provides a visual representation of the installation procedure.
Steps
- Place the palm-rest assembly at the edge of the table.
- Align the screw holes on the palm-rest assembly with the screw holes on the display hinges.
- Close the display and turn the computer over.
- Replace the four screws (M2x4.5) that secures the display hinges to the palm-rest assembly.
- Slide the display cable into the connector to connect the display cable on to the connector on the system board.
- Slide the touchscreen cable into the connector to connect the touchscreen cable on to the connector on the system board.NOTE Applicable only on computers with touchscreen configuration.
- Align and place the display-cable bracket on the display cable.
- Replace the three screws (M2x3.5) that secure the display-cable bracket to the system board.
Next steps
- Install the battery.
- Install the base cover.
- Follow the procedure in after working inside your computer.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\