Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configuring a Guest VLAN

If the supplicant does not respond within a determined amount of time ( [reauth-max + 1] * tx-period), the system assumes that the host does not have 802.1X capability and the port is placed in the Guest VLAN.

Configure a port to be placed in the Guest VLAN after failing to respond within the timeout period using the dot1x guest-vlan command from INTERFACE mode. View your configuration using the show config command from INTERFACE mode or using the show dot1x interface command from EXEC Privilege mode.

Example of Viewing Guest VLAN Configuration 

Dell(conf-if-gi-1/2)#dot1x guest-vlan 200
                                 Dell(conf-if-gi-1/2)#show config
                                 !
                                 interface GigabitEthernet 1/2
                                 switchport
                                 
                                 dot1x guest-vlan 200
                                 no shutdown
                                 Dell(conf-if-gi-1/2)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\