Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Modifying Global PVST+ Parameters

The root bridge sets the values for forward-delay and hello-time, and overwrites the values set on other PVST+ bridges.

  • Forward-delay — the amount of time an interface waits in the Listening state and the Learning state before it transitions to the Forwarding state.
  • Hello-time — the time interval in which the bridge sends bridge protocol data units (BPDUs).
  • Max-age — the length of time the bridge maintains configuration information before it refreshes that information by recomputing the PVST+ topology.

To change PVST+ parameters on the root bridge, use the following commands.

  • Change the forward-delay parameter. PROTOCOL PVST mode vlan forward-delay The range is from 4 to 30. The default is 15 seconds.
  • Change the hello-time parameter. PROTOCOL PVST mode vlan hello-time
    • NOTE: With large configurations (especially those configurations with more ports), Dell Networking recommends increasing the hello-time.
    The range is from 1 to 10. The default is 2 seconds.
  • Change the max-age parameter. PROTOCOL PVST mode vlan max-age The range is from 6 to 40. The default is 20 seconds.
The values for global PVST+ parameters are given in the output of the show spanning-tree pvst command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\