Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configuring VLT

To configure virtual link trunking and create a VLT domain in which two switches are physically connected and treated as a single port channel by access devices, you must configure the following settings on each VLT peer device.

Prerequisites: Before you begin, make sure that both VLT peer switches are running the same Dell Networking OS version and are configured for RSTP as described in RSTP Configuration. For VRRP operation, ensure that you configure VRRP groups and L3 routing on each VLT peer as described in VLT and VRRP interoperability in the Configuration Notessection.
  1. Configure the VLT interconnect for the VLT domain. The primary and secondary switch roles in the VLT domain are automatically assigned after you configure both sides of the VLTi.
    • NOTE: If you use a third-party ToR unit, to avoid potential problems if you reboot the VLT peers, Dell recommends using static LAGs on the VLTi between VLT peers.
  2. Enable VLT and create a VLT domain ID. VLT automatically selects a system MAC address.
  3. Configure a backup link for the VLT domain.
  4. (Optional) Manually reconfigure the default VLT settings, such as the MAC address and VLT primary/ secondary roles.
  5. Connect the peer switches in a VLT domain to an attached access device (switch or server).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\