Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configuring Timeouts

If the supplicant or the authentication server is unresponsive, the authenticator terminates the authentication process after 30 seconds by default. You can configure the amount of time the authenticator waits for a response.

To terminate the authentication process, use the following commands.

  • Terminate the authentication process due to an unresponsive supplicant. INTERFACE mode dot1x supplicant-timeout seconds The range is from 1 to 300. The default is 30.
  • Terminate the authentication process due to an unresponsive authentication server. INTERFACE mode dot1x server-timeout seconds The range is from 1 to 300. The default is 30.

Example of Viewing Configured Server Timeouts

The example shows configuration information for a port for which the authenticator terminates the authentication process for an unresponsive supplicant or server after 15 seconds.

The bold lines show the new supplicant and server timeouts. 

Dell(conf-if-gi-2/1)#dot1x port-control force-authorized
                                 Dell(conf-if-gi-2/1)#do show dot1x interface gigabitethernet 2/1
                                 
                                 802.1x information on Gi 2/1:
                                 -----------------------------
                                 Dot1x Status:           Enable
                                 Port Control:           FORCE_AUTHORIZED
                                 Port Auth Status:       UNAUTHORIZED
                                 Re-Authentication:      Disable
                                 Untagged VLAN id:       None
                                 Guest VLAN:             Disable
                                 Guest VLAN id:          NONE
                                 Auth-Fail VLAN:         Disable
                                 Auth-Fail VLAN id:      NONE
                                 Auth-Fail Max-Attempts: NONE
                                 Tx Period:              90 seconds
                                 Quiet Period:           120 seconds
                                 ReAuth Max:             10
                                 
                                 Supplicant Timeout:  15 seconds
                                 Server Timeout:         15 seconds
                                 Re-Auth Interval:       7200 seconds
                                 Max-EAP-Req:            10
                                 Auth Type:              SINGLE_HOST
                                 Auth PAE State:         Initialize
                                 Backend State:          Initialize
Enter the tasks the user should do after finishing this task (optional).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\