Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Resetting a Unit on a Stack

Use the following reset command to reload any of the member units or the standby in a stack. If you try to reset the stack master, the following error message is displayed: 

% Error: Reset of master unit is not allowed.

To reset a unit on a stack, use the following command:

  • Reset any designated stack member, except the management unit. EXEC Privilege mode reset stack-unit unit-number {hard}
  • Hard reset any stack unit including master unit. EXEC Privilege mode power-cycle stack-unit [ unit-number]

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\