Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configuring Layer 2 (Interface) Mode

To configure an interface in Layer 2 mode, use the following commands.

  • Enable the interface. INTERFACE mode no shutdown
  • Place the interface in Layer 2 (switching) mode. INTERFACE mode switchport
For information about enabling and configuring the Spanning Tree Protocol, refer to Spanning Tree Protocol (STP) .

To view the interfaces in Layer 2 mode, use the show interfaces switchport command in EXEC mode.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\