Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip msdp originator-id

Configure the MSDP Originator ID.

Syntax

ip msdp originator-id { interface}

To remove the originator-id, use the no ip msdp originator-id { interface} command.

Parameters

interface

Enter the following keywords and slot/port or number information:

For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
For a VLAN, enter the keyword vlan then a number from 1 to 4094.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.