Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug protocol-tunnel

Enable debugging to ensure incoming packets are received and rewritten to a new MAC address.

Syntax

debug protocol-tunnel interface {in | out | both} [vlan vlan-id] [count value]

To disable debugging, use the no debug protocol-tunnel interface {in | out | both} [vlan vlan-id] [count value] command.

Parameters

interface	Enter one of the following interfaces and slot/port information: For a Port Channel interface, enter the keywords `port-channel` then a number. The range is from 1 to 128. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information.
in \| out \| both	Enter the keyword `in`, `out`, or `both` to debug incoming interfaces, outgoing interfaces, or both incoming and outgoing interfaces.
vlan vlan-id	Enter the keyword `vlan` then the VLAN ID. The range is from 1 to 4094.
count value	Enter the keyword `count` then the number of debug outputs. The range is from 1 to 100.

Defaults

Debug disabled.

Command Modes

EXEC Privilege

Supported Modes

Full–Switch Mode

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.