Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

router isis

Allows you to enable the IS-IS routing protocol and to specify an IP IS-IS process.

Syntax

router isis [ tag]

To disable IS-IS routing, use the no router isis [ tag] command.

Parameters

tag

(OPTIONAL) This is a unique name for a routing process. A null tag is assumed if the tag option is not specified. The tag name must be unique for all IP router processes for a given router.

Defaults

Not configured.

Command Modes

ROUTER ISIS

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Configure a network entity title (the net command) to specify the area address and the router system ID.

Enable routing on one or more interfaces to establish adjacencies and establish dynamic routing.

You can configure only one IS-IS routing process to perform Level 2 routing. A level-1-2 designation performs Level 1 and Level 2 routing at the same time.

Related Commands

ip router isis — configures IS-IS routing processes for IP on interfaces and attaches an area designator to the routing process.
net — configures an IS-IS network entity title (NET) for a routing process.
is-type — assigns a type for a given area.