Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ntp associations

Display the NTP master and peers.

Syntax

show ntp associations

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ntp associations command shown in the following example.

Field	Description
(none)	One or more of the following symbols could be displayed: * means synchronized to this peer. # means almost synchronized to this peer. + means the peer was selected for possible synchronization. - means the peer is a candidate for selection. ~ means the peer is statically configured.
remote	Displays the remote IP address of the NTP peer.
ref clock	Displays the IP address of the remote peer’s reference clock.
st	Displays the peer’s stratum, that is, the number of hops away from the external time source. A 16 in this column means the NTP peer cannot reach the time source.
when	Displays the last time the switch received an NTP packet.
poll	Displays the polling interval (in seconds).
reach	Displays the reachability to the peer (in octal bitstream).
delay	Displays the time interval or delay for a packet to complete a round-trip to the NTP time source (in milliseconds).
offset	Displays the relative time of the NTP peer’s clock to the switch clock (in milliseconds).
disp	Displays the dispersion.

Example

Dell#show ntp associations
                                             remote        ref clock  st when poll reach delay  offset disp
                                             =============================================================
                                             10.10.120.5  0.0.0.0       16   -   256    0 0.00 0.000 16000.0
                                             *172.16.1.33  127.127.1.0   11   6   16     377   -0.08 -1499.9 104.16
                                             172.31.1.33  0.0.0.0       16   -   256    0 0.00 0.000 16000.0
                                             192.200.0.2  0.0.0.0       16   -   256    0 0.00 0.000 16000.0
                                             * master (synced), # master (unsynced), + selected, - candidate
                                             Dell#

Related Commands

show ntp status — displays the current NTP status.