Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

BOOT_USER # help
                                             ***** Dell Force10 Boot Interface Help Information *****
                                             Current access level: USER LEVEL
                                             Use "syntax help" for more information on syntax.
                                             Available command list (22 commands total):
                                             boot change [primary|secondary|default]
                                             change operating system boot parameters
                                             boot selection [a|b]
                                             change the rom bootstrap bootflash partition
                                             boot show net config retries
                                             show number of retries for network boot config failure
                                             boot write net config retries <int>
                                             write number of retries for network boot config failure
                                             boot zero [primary|secondary|default]
                                             zero operating system boot parameters
                                             default-gateway <ip-address>
                                             default-gateway - set the default gateway ip address
                                             enable [user|admin]
                                             change access privilege level
                                             help
                                             display help menu
                                             -(36%)-Use <CR> to continue, q to stop:
                                             BOOT_USER #