Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show interfaces description

Display the descriptions configured on the interface.

Syntax show interfaces [ interface] description
Parameters
interface Enter one of the following keywords and slot/port or number information:
  • For the management interface on the stack unit enter the keyword ManagementEthernet followed by the slot/port information. The slot range is 0-0 and the port range is 0.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information.
  • For VLAN interfaces, enter the keyword vlan followed by a number from 1 to 4094.
  • NOTE: This command also enables you to view information corresponding to a range of ports.
    • You can specify multiple ports as slot/port-range. For example, if you want to display information corresponding to all ports between 1 and 4, specify the port range as show interfaces interface-type 1/1 - 4 .
Command Modes
  • EXEC
  • EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface configurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The following describes the show interfaces description command shown in the Example below.
Field Description
Interface Displays the type of interface and associated slot and port number.
OK? Indicates if the hardware is functioning properly.
Status States whether the interface is enabled (up) or disabled (administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the interface.
Description Displays the description (if any) manually configured for the interface.
Example
Dell#show interface description
                                             Interface              OK  Status      Protocol    Description
                                             TenGigabitEthernet 0/1 NO  admin down  down
                                             TenGigabitEthernet 0/2 NO admin up     down
                                             TenGigabitEthernet 0/3 NO admin up     down
                                             TenGigabitEthernet 0/4 NO admin up     down
                                             TenGigabitEthernet 0/5 NO admin up     down
                                             TenGigabitEthernet 0/6 NO admin up     down
                                             TenGigabitEthernet 0/7 NO up down
                                             TenGigabitEthernet 0/8 YES up up
                                             
                                          

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\