Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

match ip access-group

Configure match criteria for a class map, based on the access control list (ACL).

Syntax

match ip access-group access-group-name [set-ip-dscp value]

To remove ACL match criteria from a class map, use the no match ip access-group access-group-name [set-ip-dscp value] command.

Parameters

access-group-name	Enter the ACL name whose contents are used as the match criteria in determining if packets belong to the class the `class-map` specifies.
set-ip-dscp value	(OPTIONAL) Enter the keywords `set-ip-dscp` then the IP DSCP value. The matched traffic is marked with the DSCP value. The range is from 0 to 63.

Defaults

none

Command Modes

CLASS-MAP CONFIGURATION (config-class-map)

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM..
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

To access this command, enter the class-map command. After the class map is identified, you can configure the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed. For class-map match-all, only one ACL match criteria is allowed.

Related Commands

class-map — identifies the class map.