Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

stack-unit iom-mode

Toggle the operating mode between programmable multiplex, standalone, stack, full–switch,and VLT modes.

Syntax

stack-unit < unit-number> iom-mode [programmable-mux | stack | standalone | vlt | full-switch

Parameters

unit number <0-5>	Enter the number of the member stack unit. The range is from 0 to 5.
programmable-mux	Enable programmable multiplex mode.
stack	Enable stack mode.
standalone	Enable stand-alone mode.
vlt	Enable virtual link trunking mode.
full-switch	Enable full-switch mode.

Defaults

standalone

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.6.(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

This command is supported on the M I/O, FN410S, and FN410T Aggregators.

Example

Dell(conf)#stack-unit 0 iom-mode stack
                                             % You are about to stack your IOA module, please reload the IOA
                                             and then plug in the stacking cable for the changes to take effect.
                                             Dell(conf)#
                                             Dell#

Related Commands

reload— Reboots the operating system.

show system— displays the current status of all stack members or a specific member.