Dell Chassis Management Controller Version 3.0 for PowerEdge VRTX RACADM CLI Guide

testtrap


Description	Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRAC to a specified destination trap listener on the network. To use this subcommand, you must have the Test Alerts privilege. NOTE Before you execute the testtrap subcommand, make sure that the specified index in the RACADM cfgAlerting group is configured properly.
Synopsis	racadm testtrap -i <index>
Input	-i — Specifies the index of the trap configuration to be used for the test. Valid values are from 1 to 4.
Example	Commands for the cfgIpmiPet group: Enable the alert racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 1 Set the destination e-mail IP address racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIpAddr -i 1 192.168.0.110 View the current test trap settings racadm getconfig -g cfgIpmiPet -i <index> where <index> is a number from 1 to 4.