- Notes, cautions, and warnings
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
Velkommen
Dell-websteder
Dell-websteder
Velkommen hos Dell
Min konto
- Afgiv ordrer hurtigt og nemt
- Se ordrer og spor status for din forsendelse
- Opret og få adgang til en liste med dine produkter
- Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
Installing the control panel
Prerequisites
CAUTION: Many
repairs may only be done by a certified service technician. You should
only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by
Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a field replaceable
unit (FRU). Removal and installation procedures must be performed
only by Dell certified service technicians.
- Ensure that you read the Safety instructions.
- Follow the procedure listed in Before working inside your system.
- Remove the control panel. NOTE: You must remove the control panel to replace a faulty control panel.
Steps
- Connect the control panel cable to the control panel.
- Press the ZIF connector release latch into place.
- Install the screw to secure the control panel cover to the control panel.
- Align the screw holes on the control panel with the screw holes on the side of the system.
- Install the two screws to secure the control panel to the side of the system.
- Insert the control panel cable in the cable tube.
- Align the screw holes on the cable tube with the screw holes on the side of the system.
- Install the three screws to secure the cable tube to the side of the system.
Next steps
Angiv vurderinger (1-5 stjerner).
Angiv vurderinger (1-5 stjerner).
Angiv vurderinger (1-5 stjerner).
Angiv, om artiklen var nyttig eller ej.
Kommentarer må ikke indeholde følgende specialtegn: <>()\