Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual

PDF

Removing the control panel

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified service technicians.
NOTE: You must remove the control panel to replace a faulty control panel.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Remove the three screws that secure the cable tube to the side of the system and remove the cable tube.
  2. Remove the two screws that secure the control panel to the system.
    Figure 1. Removing and installing the cable tube
    This figure shows removing and installing the cable tube.
    1. control panel
    2. screw (5)
    3. cable tube
    4. control panel cable
  3. Remove the screw that secures the control panel cover to the control panel.
  4. Release the ZIF connector latch.
  5. Using the pull-tab, remove the control panel cable from the control panel.
    NOTE: To prevent damage to the control panel cable, exercise utmost care when removing the control panel cable from the control panel.
  6. Remove the control panel from the system.
    Figure 2. Removing and installing the control panel
    This figure shows removing and installing the control panel.
    1. ZIF connector latch
    2. connector
    3. control panel cover
    4. screw

Next steps

Install the control panel.

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\