Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerVault ME4 Series Storage System Deployment Guide

PDF

Isolating replication faults

Replication is a disaster-recovery feature that performs asynchronous replication of block-level data from a volume in a primary storage system to a volume in a secondary storage system.

The replication feature creates an internal snapshot of the primary volume, and copies changes to the data since the last replication to the secondary system using iSCSI or FC connections. The primary volume exists in a primary pool in the primary storage system. Replication can be completed using either the PowerVault Manager or the CLI.

Replication setup and verification

After storage systems are cabled for replication, you can use the PowerVault Manager to prepare for using the replication feature. Alternatively, you can use SSH or telnet to access the IP address of the controller module and access the replication feature using the CLI.

Basic information for enabling the ME4 Series Storage System controller enclosures for replication supplements the troubleshooting procedures that follow.

  • Familiarize yourself with replication content provided in the Dell PowerVault ME4 Series Series Storage System Administrator’s Guide.
  • For virtual replication, perform the following steps to replicate an existing volume to a pool on the peer in the primary system or secondary system:
    1. Find the port address on the secondary system:

      Using the CLI, run the show ports command on the secondary system.

    2. Verify that ports on the secondary system can be reached from the primary system using either of the following methods:
      • Run the query peer-connection CLI command on the primary system, using a port address obtained from the output of the show ports command.
      • In the PowerVault Manager Replications topic, select Action > Query Peer Connection.
    3. Create a peer connection.

      To create a peer connection, use the create peer-connection CLI command or in the PowerVault Manager Replications topic, select Action > Create Peer Connection.

    4. Create a virtual replication set.

      To create a replication set, use the create replication-set CLI command or in the PowerVault Manager Replications topic, select Action > Create Replication Set.

    5. Replicate.

      To initiate replication, use the replicate CLI command or in the PowerVault Manager Replications topic, select Action > Replicate.

  • Using the PowerVault Manager, monitor the storage system event logs for information about enclosure-related events, and to determine any necessary recommended actions
NOTE:These steps are a general outline of the replication setup. Refer to the following manuals for more information about replication setup:
  • See the Dell PowerVault ME4 Series Series Storage System Administrator’s Guide for procedures to set up and manage replications.
  • See the Dell PowerVault ME4 Series Series Storage System CLI Guide for replication commands and syntax.
NOTE:Controller module firmware must be compatible on all systems that are used for replication.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\