Perform the following steps to create and mount an XFS file system:
From the
multipath -l command output, identify the device multipath to target when creating a file system.
In this example, the first time that multipath is configured, the first device is
/dev/mapper/mpatha and it corresponds to
sg block devices
/dev/sdb and
/dev/sdd.
NOTE:Run the
lsscsi command to list all SCSI devices from the Controller/Target/Bus/LUN map. This command also identifies block devices per controller.
Run the
mkfs.xfs /dev/mapper/mpatha command to create an xfs type file system.
Run the
mkdir /mnt/VolA command to create a mount point for this file system with a referenced name, such as VolA.
Run themount /dev/mapper/mpatha /mnt/VolA command to mount the file system.
Begin using the file system as any other directory to host applications or file services.
Repeat steps 1–5 for each provisioned volume in
PowerVault Manager. For example, the device
/dev/mapper/mpathb corresponds to
sg block devices
/dev/sdc and
/dev/sde .
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\