The following sections describe the connection to the mini-USB port:
Emulated serial port
When a computer is connected to a controller module using a mini-USB serial cable, the controller presents an emulated serial port to the computer. The name of the emulated serial port is displayed using a
customer vendor ID
and
product ID. Serial port configuration is unnecessary.
NOTE:Certain operating systems require a device driver or special mode of operation to enable proper functioning of the USB CLI port. See also
Device driver/special operation mode.
Supported host applications
The following terminal emulator applications can be used to communicate with an
ME4 Series controller module:
When the computer detects a connection to the emulated serial port, the controller awaits input of characters from the computer using the command-line interface. To see the CLI prompt, you must press Enter.
NOTE:Directly cabling to the mini-USB port is considered an out-of-band connection. The connection to the mini-USB port is outside of the normal data paths to the controller enclosure.
Device driver/special operation mode
Certain operating systems require a device driver or special mode of operation. The following table displays the product and vendor identification information that is required for certain operating systems:
Table 2. USB identification codeUSB Identification code for certain operating systems
USB identification code type
Code
USB Vendor ID
0x210c
USB Product ID
0xa4a7
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\