Perform the following steps to set IPv6 addresses for the network ports:
In the
Welcome panel, select
System Settings, and then click the
Network tab.
Select the
IPv6 tab.
IPv6 uses 128-bit addresses.
Select the type of IP address settings to use for each controller from the
Source drop-down menu:
Select
Manual to specify up to four static IP addresses for each controller.
Select
Auto to allow the system to automatically obtain IP addresses.
If you chose
Manual, perform the following steps for each controller:
Click
Add Address.
Type the IPv6 addresses in the
IP Address field.
Type a label for the IP address in the
Address Label field.
Click
Add.
Record the IPv6 address.
NOTE:The following IP addresses are reserved for internal use by the storage system: 169.254.255.1, 169.254.255.2, 169.254.255.3, 169.254.255.4, and 127.0.0.1. Because these addresses are routable, do not use them anywhere in your network.
If you selected
Auto, complete the remaining steps to allow the controllers to obtain IP addresses.
Click
Apply.
A confirmation panel appears.
Click
OK.
Sign out and use the new IP address to access
PowerVault Manager.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\