NOTE:You cannot delete or
change an existing system or setup password if the Password
Status is set to Locked.
Steps
To enter System Setup, press F2 immediately
after turning on or restarting your system.
On the System Setup Main Menu screen, click System BIOS > System Security.
On the System Security screen, ensure that Password Status is set
to Unlocked.
In the System Password field, alter or delete the existing system password, and then press
Enter or Tab.
In the Setup Password field, alter or delete the existing setup password, and then press
Enter or Tab.
If you change the system and setup password, a
message prompts you to reenter the new password. If you delete the
system and setup password, a message prompts you to confirm the deletion.
Press Esc to return to the System
BIOS screen. Press Esc again, and a message prompts you
to save the changes.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\