CAUTION:Many
repairs may only be done by a certified service technician. You should
only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by
Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Follow the safety guidelines listed in the Safety
instructions section.
Follow the procedure listed in the Before working
inside your system section.
If connected, disconnect all USB
devices.
If installed, remove the SD card(s).
Remove the SSD cage.
Keep the Phillips #2 screwdriver ready.
Steps
Remove the screws securing the IDSDM card
to the SSD cage.
Lift the IDSDM card till it disengages from
the standoff and slide the IDSDM card away out of the SSD cage.
CAUTION:To prevent damage to the IDSDM card, you must hold
the card only by its edges.
Figure 1. Removing the
IDSDM card
screw (2)
screw hole (2)
standoff (1)
SSD cage
IDSDM card
Next steps
Install the SSD cage.
Install the IDSDM card.
If applicable, install the SD cards.
Reconnect any disconnected USB devices.
Follow the procedure listed in the After working
inside your system section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\