CAUTION:Many
repairs may only be done by a certified service technician. You should
only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by
Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the
IDSDM card to replace a faulty IDSDM card.
Follow the safety guidelines listed in the Safety
instructions section.
Follow the procedure listed in the Before working
inside your system section.
Remove the SD card.
Disconnect any connected USB devices.
Remove the SSD cage.
Remove the IDSDM card.
Keep the Phillips #2 screwdriver
ready.
CAUTION:To prevent damage to the IDSDM card, you must hold the card only
by its edges.
Steps
Slide the IDSDM card into the slot on the SSD
cage.
Align the IDSDM card with the standoff on the
SSD cage and the USB port slots on the front panel.
Secure the IDSDM card to the SSD cage with
the screws.
Next steps
Install the SSD cage.
If applicable, install the SD card(s).
If applicable, reconnect any disconnected
USB devices.
Follow the procedure listed in the After working
inside your system section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\