CAUTION:When
a replacement hot swappable SSD is installed and the sled is powered on, the SSD automatically
begins to rebuild. Make absolutely sure that the replacement SSD is
blank or contains data that you wish to have over-written. Any data
on the replacement SSD is immediately lost after the SSD is installed.
NOTE: You must remove
an SSD to upgrade an SSD or replace a faulty SSD.
Follow the safety guidelines listed in the Safety
instructions section.
Remove the SSD blank.
Install the SSD in the SSD carrier.
NOTE:All operating
systems do not support hot swappable drive installation. See the documentation
supplied with your operating system.
Steps
Press the release button to open the SSD carrier
handle.
Slide the SSD carrier into the drive bay and
push it until the handle makes contact with the sled.
Rotate the carrier handle to the closed position
while pushing the carrier into the slot until it locks into place.
The status LED indicator displays a steady green
light if the drive is installed correctly. The drive carrier LED green
indicator flashes as the drive rebuilds.
Next steps
Follow the procedure listed in the After working inside your system
section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\