CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
CAUTION:Never remove the heat sink from a processor unless you intend to
remove the processor. The heat sink is necessary to maintain proper
thermal conditions.
NOTE:This
is a Field Replaceable Unit (FRU). Removal and installation procedures
should be performed only by Dell certified service technicians.
NOTE:To ensure proper system
cooling, you must install a processor blank in any empty processor
socket.
Follow the safety guidelines listed in the Safety
instructions section.
Follow the procedure listed in the Before working
inside your system section.
Remove the cooling shroud.
Keep the Phillips #2 screwdriver
ready.
WARNING:The heat sink will be hot to touch for some time after the system
has been powered down. Allow the heat sink to cool before removing
it.
Steps
To remove a 120 W heat sink, perform the following
steps.
Loosen one of the screws that secure the
heat sink to the system board.
Wait 30 seconds for the heat sink to loosen from
the processor.
Remove the screw diagonally opposite the
screw you first removed.
Repeat the procedure for the remaining two
screws.
To remove a 140 W heat sink, perform the following
steps.
Loosen one of the screws that secure the
heat sink over CPU 1 to the system board.
Wait 30 seconds for the heat sink to loosen from
the processor.
Remove the screw diagonally opposite the
screw you first removed.
Repeat the procedure for the remaining four
screws.
Next steps
Remove the processor.
Follow the procedure listed in the After working inside
your system section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\