CAUTION:Many
repairs may only be done by a certified service technician. You should
only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by
Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the
LOM riser card to replace a faulty LOM riser card or service other
components inside the system.
Follow the safety guidelines listed in the Safety
instructions section.
Follow the procedure listed in the Before working
inside your system section.
Keep the Phillips #2 screwdriver
ready.
Steps
Align the screw holes on the card with the
standoffs on the system board.
CAUTION: To prevent damage to the LOM riser card, you must
hold the card only by its edges.
Press the card into place until the card connector
fits into the corresponding connector on the system board.
Secure the card with the two screws.
Next steps
Follow the
procedure listed in the After working inside your system section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\