- Notes, cautions, and warnings
- Working on your computer
- Removing and
installing components
- Recommended tools
- Screw size list
- Subscriber Identification Module (SIM) card
- Base cover
- Battery
- PCIe Solid State Drive (SSD)
- M2. SATA Solid State Drive (SSD)
- Speaker
- Coin-cell battery
- WWAN card
- WLAN card
- Memory modules
- Heat sink
- Power connector port
- LED board
- Smart card module
- Touchpad
- Display Assembly
- Display hinge cap
- System board
- Keyboard assembly
- Keyboard lattice and Keyboard
- Palm rest
- Technology and components
- System specifications
- System specifications
- Processor specifications
- Memory specifications
- Video specifications
- Audio specifications
- Battery specifications
- AC adapter specifications
- Touchpad specifications
- Port and connector specifications
- Communication specifications
- Camera specifications
- Display
- Dimensions and Weight
- Environmental specifications
- System setup
- Software
- Troubleshooting
- Contacting Dell
Dell Latitude 7390 Owner's Manual
Installing LED board
- Insert the LED board into the slot on the computer.
- Tighten the M2 x 2.5 screw (1) to secure the LED board.
- Connect the LED cable to the system board.
- Install the :
- Follow the procedure in After working inside your computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\