Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell Latitude 7390 Owner's Manual

PDF

Installing system board

  1. Place the USB Type-C port along with the bracket in the slot on the system board.
  2. Affix the tape to secure the Type-C bracket.
  3. Flip the system board and tighten the M2 x 3 screws to secure the USB type-C port to the system board.
  4. Align the system board with the screw holders on the computer.
  5. Tighten the M2 x 3 screws to secure the system board to the computer.
  6. Connect the speaker, power connector, LED board, touchpad, and USH cables to the connectors on the system board.
  7. Connect the eDP cable to the connector on the system board.
  8. Place the metal bracket over the eDP cable and tighten the M2 x 3 screws to secure it.
  9. Remove the metal bracket from the memory module connectors of the system board that was removed.
  10. Place the metal bracket over the memory module connectors and tighten the M2 x 3 screws to secure it to the computer.
    • NOTE: If your computer has a WWAN card, then SIM card tray installation is a requirement.
  11. Install the:
    1. coin cell battery

    2. heat sink

    3. WLAN card

    4. WWAN card

    5. SSD card

    6. memory module

    7. speaker

    8. battery

    9. base cover

  12. Follow the procedure in After working inside your computer .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\