Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge C4130 Owner's Manual

Installing the expansion card riser

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

  1. Follow the safety guidelines listed in the Safety instructions section.

Steps

  1. Align the expansion card riser board with the expansion card riser cage.
  2. Tighten the screws to secure the expansion card riser board to the expansion card riser cage.
    Figure 1. Installing the expansion card riser board
    This image shows how to Install the expansion card riser board.
    1. screw (2)
    2. cabled expansion riser board
    3. expansion card riser cage
    4. expansion card riser board
    5. screw (2)

Next steps

  1. If applicable, connect the riser cables to the system board/NVLink board.
  2. If applicable, install the expansion card.
  3. Install the expansion card riser cage.
  4. Follow the procedure listed in the After working inside your system section.
  5. Install any device drivers required for the expansion card. For more information, see the documentation for the card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\